Much better than STM32F1 and F3
All 5V/9V Output with LC Filter
Preview (drag to change position)
1*3.3V/1*4.5V/3*5.0V/1*9.0V Output
Direct power to the ESCs
MCU | STM32F405 |
IMU | MPU6000 |
OSD | BetaFlight OSD w/ AT7456E chip |
BLE Module | Inner connect to UART5 for remote setting with Speedy Bee App or other similar apps |
BlackBox | 16MB onboard dataflash |
Current Sensor | 200A(Scale 302) |
Power input | 3s - 6s Lipo |
Power output | 4.5V * 1 , 3.3V * 1, 5V * 3(Max.2A) , 9V * 1(Max.2A) |
Cam And VTX power output | Built-in LC-Filter for 5V and 9V |
ESC power output | 4 * VCC output |
UART | UART Pads * 3(UART1, UART3, UART4) |
UART2 for Receiver | Built in inverter of RX2 for SBUS input through SBUS pad, RX2 pad used for PPM, DSM2, DSMX, IBUS |
RSSI input | RSSI input solder pad |
I2C | Used for external GPS, Barometer module |
Buzzer | Buz- and 5V pad used for 5V Buzzer |
ESC signal | s1 - s7 |
LED pin | Used for WS2812 LED |
Boot button | Used to easy enter DFU mode |
Weight | ≈8.8g |
Dimension | 36*39*7mm |
Posted by jeff on 1st Aug 2018
Good board, performs well but could do with a better escs reconfiguration as it stands they are on the side of the board and esc wires come out of the side, could of have turned board 90 degrees but that puts the USB plug facing front or back, apart from that performs very well without any tuning
Posted by Reinhard on 22nd Jul 2018
Great FC, finally someonehas listened to us users who need deep LC filtered voltage supply for cam / VTX - AND - for the onboard OSD which otherwise introduces a lot of video noise. Direct cam control over OSD is another super-nice feature!
Posted by Greg Rasmus on 19th Jul 2018
Flies very nice right out of box.
Posted by markus@richert.com on 14th Jul 2018
Hassle free on the fly PID changes, Rate or even CLI-entries are as easy as can be. Thumbs up!!